Campusleben_HAW_Hamburg_28

Lehrende_HAW_Hamburg_9

Studierende_HAW_Hamburg_24

Informationen für:

Publikationen von Professorinnen und Professoren der HAW Hamburg

Jahr:  
Alle : 1982, ... , 2009, 2010, 2011, ... , 2019
Autor:  
Alle : A, À, B, C, D, E, F, G, H, I, J, K, L, M, N, O, Ö, P, Q, R, S, T, U, V, W, Y, Z 
Alle : W. Biersack, ... , Wetzel, Weyand, Weyhe, ... , Wöste 
Präferenzen: 
Referenzen pro Seite: Zeige Schlüsselwörter Zeige Zusammenfassung
Referenzen

Zeitschriftenbeiträge:

default
Doris Wilborn, Ulrike Grittner, Theo Dassen und Jan Kottner
The National Expert Standard Pressure Ulcer Prevention in Nursing and pressure ulcer prevalence in German health care facilities : a multilevel analysis
Journal of Clinical Nursing, 19(23-24):3364-3371
2010

Marker: WS-PM

default
Ursula Weisenfeld, Constanze Sörensen und Christian Scherer
Ärztliche Dienstleistung: eine Zufriedenheitsbefragung bei Patienten und niedergelassenen Ärzten
Gesundheitswesen, 72((5)):259-270
2010

Marker: WS-P&M

default
Thomas C. Schmidt, Matthias Wählisch und Maik Wodarz
Fast Adaptive Routing Supporting Mobile Senders in Source Specific Multicast
Telecommunication Systems, 43(1):95--108
2010

Marker: TI-I

Zusammenfassung: IP multicast deployment recently progresses, but group services often remain restricted to limited domains and fail to comply with route-optimizing mobility management of the next generation Internet. Source Specific Multicast (SSM) facilitates transparent inter-domain routing and is expected to globally disseminate to many users and services. However, mobility support for Source Specific Multicast is still known to be a major open problem. In this paper, we propose the Enhanced Tree Morphing (ETM) protocol for extending SSM routing to mobile multicast sources. The scheme dynamically adapts SSM forwarding states to sender mobility, and transforms (morphs) source specific distribution trees into new, optimal trees rooted at a relocated source. ETM is simple, robust and secure, while it admits superior performance in packet forwarding at a low signaling overhead. Extensive evaluations based on a full protocol implementation, and simulations based on real-world topology data are performed, granting full insight into the properties of packet loss and delay stretch, protocol convergence times and router state evolution during single and rapidly repeated handovers. In a constant bit rate scenario, an ETM source handover typically leads to a slightly increasing delay of the first data packet, only. When operating on realistic network topologies, the protocol uniformly converges within less than 50 ms, thereby sustaining robustness under rapid source movement at all speeds common to our mobile world. Further optimizations are identified for FMIPv6 and for multihomed nodes.

Bücher/Monographien:

default
P. Wratil, M. Kieviet und Werner Röhrs
Sicherheit für Maschinen und Anlagen : Mechanische Einheiten, elektronische Systeme und sicherheitsgerichtete Programmierung
Verlag: VDE, Berlin u.a.
2010

Marker: WS-W

Konferenz, Symposium, Vortragsreihe, Einzelausstellung, Modenschau, Künstl. Leitung (als Ausrichter):

default
V. Schulte, Chr. Augustin und T. Willner
Cracked Vegetable Oils (CVO) as a Basis for Future Biofuels
International Conference on Renewable Energy and Climate Change – Focus on the Pacific (ICRECC10), Suva, Fiji

Marker: LS-VT

default
Patrick Diffo, Peter Wulf und Michael Breuer
Toward the five-way-coupling of air-fiber-droplet phases for the spray molding manufacturing process of polyurethane-fiber-reinforced composites
8th Euromech Fluid Mechanics Conference
Bad Reichenhall, Germany

Marker: TI-MP

default
Patrick Diffo, Peter Wulf, Ferdinand Olawsky, Dietmar Hietel und Michael Breuer
Dynamics of finite fibers exposed to a spray field in the polyurethane-fiber-reinforced composite spray molding manufacturing process
1st Conference on Multiphysics Simulation
Fraunhofer NUSIM, Bonn

Marker: TI-MP

default
Patrick Diffo, Peter Wulf und Michael Breuer
Multiple-Way-Coupling of Air-Fiber-Droplet Phases in the Polyurethane-Fiber-Reinforced Composite Spray Molding Manufacturing Process
Proceedings of the International Conference on Multiphase Flow 2010 (ICMF-2010)
Tampa, USA

Marker: TI-MP

default
Peter Wulf und Patrick Diffo
Modellierung und Simulation der gekoppelten 3-Phasenströmung des PUR-Fasersprühverfahrens
2. Norddeutsches Simulationsforum
Hamburg, Germany

Marker: TI-MP

default
Patrick Diffo, Peter Wulf und Michael Breuer
Computation of the Coupled Dynamics of Fibers in a Spray
GAMM 2010. 81st Annual Scientific Conference
Karlsruhe, Germany

Marker: TI-MP

Seite:  
Zurück | 1, 2, 3, 4, 5, 6 | Weiter
Total:
1015
Export als:
BibTeX, XML

Letzte Änderung: 23.01.15

An die Redaktion